Threat Intelligence Database

In the Linux kernel, the following vulnerability has been resolved: net: hip04: fix RX buffer leak on build_skb failure When build_skb() fails in hip04_rx_poll(), the driver jumps to the refill path without releasing the current RX buffer and its DMA mapping. Installing a replacement buffer then overwrites the slot references and leaks both resources. Keep the current slot intact and return budget so NAPI retries the same buffer. Also free a newly allocated RX fragment when dma_map_single() fails. This issue was found by an in-house static analysis tool.

In the Linux kernel, the following vulnerability has been resolved: net: gro: fix double aggregation of flush-marked skbs Commit 0ab03f353d36 ("net-gro: Fix GRO flush when receiving a GSO packet.") added a flush check to skb_gro_receive(), but skb_gro_receive_list() lacks the same validation. As a result, packets marked with NAPI_GRO_CB(skb)->flush may still be re-aggregated. This allows already-GRO'd packets with existing frag_list to be re-aggregated into a new GRO session, corrupting the frag_list chain structure. When skb_segment() attempts to unpack these malformed packets, it encounters invalid state and triggers a kernel panic. Scenario (Tethering/Device forwarding): 1. Driver: Generated aggregated packet P1 via LRO with frag_list 2. Dev A: Receives aggregated fraglist packet and flush flag set 3. Dev A: Re-enters GRO, skb_gro_receive_list() is called 4. Missing flush check allows re-aggregation despite flush flag 5. Frag_list chain becomes corrupted (loops or dangling refs) 6. Dev B: TX path calls skb_segment(), crashes on corrupted frag_list Root cause in skb_segment(): The check at line ~4891: if (hsize <= 0 && i >= nfrags && skb_headlen(list_skb) && (skb_headlen(list_skb) == len || sg)) { When frag_list is corrupted by double aggregation, when list_skb is a NULL pointer from skb->next, skb_headlen(list_skb) dereference NULL/corrupted pointers occurs. Call Trace: skb_headlen(NULL skb) skb_segment tcp_gso_segment tcp4_gso_segment inet_gso_segment skb_mac_gso_segment __skb_gso_segment skb_gso_segment validate_xmit_skb validate_xmit_skb_list sch_direct_xmit qdisc_restart __qdisc_run qdisc_run net_tx_action Fix: Add NAPI_GRO_CB(skb)->flush validation to the early-return check in skb_gro_receive_list(), matching the defensive programming pattern of skb_gro_receive().

In the Linux kernel, the following vulnerability has been resolved: net/x25: fix use-after-free in x25_kill_by_neigh() x25_kill_by_neigh() walks the global X.25 socket list looking for sockets attached to a terminating neighbour. x25_list_lock protects list membership while the lookup is in progress, but it does not pin a socket's lifetime after the lock is dropped. The function currently drops x25_list_lock before calling lock_sock(s). A concurrent close can run x25_release(), remove the same socket from x25_list, and drop the last socket reference in that window. The neighbour teardown path can then lock or inspect a freed struct sock/struct x25_sock. Take sock_hold(s) while x25_list_lock still proves that the list entry is live, then drop the temporary reference after the socket has been locked, rechecked, and released. Recheck x25_sk(s)->neighbour after lock_sock(), because another path may have disconnected the socket before this path acquired the socket lock. Restart the list walk after each disconnect because the list lock was dropped and the previous iterator state may no longer be valid. A QEMU/KASAN run against origin/master reproduced a slab-use-after-free in x25_kill_by_neigh().

In the Linux kernel, the following vulnerability has been resolved: net/sched: serialize qdisc_rtab_list against concurrent get/put qdisc_get_rtab() and qdisc_put_rtab() mutate the process-global singly linked list qdisc_rtab_list and a plain non-atomic 'int refcnt' with no lock. This was only safe because every caller historically held the RTNL mutex, which serialized all rate-table lookups, inserts and frees. That invariant no longer holds. cls_flower sets TCF_PROTO_OPS_DOIT_UNLOCKED, so tc_new_tfilter() keeps rtnl_held == false for it and sets TCA_ACT_FLAGS_NO_RTNL. That flag propagates through tcf_exts_validate_ex() -> tcf_action_init() -> tcf_action_init_1() -> tcf_police_init(), which calls qdisc_get_rtab()/qdisc_put_rtab() with the RTNL mutex NOT held. Two RTM_NEWTFILTER requests on different CPUs, each adding a flower filter with a police action carrying the same rate, then race on qdisc_rtab_list and on the non-atomic refcnt, leading to a use-after-free / double-free of the kmalloc-2k struct qdisc_rate_table. qdisc_rtab_list is a single global (not per-netns), so the corrupted object is shared system-wide. BUG: KASAN: slab-use-after-free in qdisc_put_rtab+0x12f/0x160 qdisc_put_rtab+0x12f/0x160 tcf_police_init+0xda9/0x1590 tcf_action_init_1+0x460/0x6b0 tcf_action_init+0x439/0xa40 tcf_exts_validate_ex+0x42d/0x550 fl_change+0xddd/0x7da0 tc_new_tfilter+0xaa7/0x2420 rtnetlink_rcv_msg+0x95e/0xe90 which belongs to the cache kmalloc-2k of size 2048 Protect qdisc_rtab_list and the refcount with a dedicated spinlock. The (sleeping, GFP_KERNEL) allocation in qdisc_get_rtab() is performed before taking the lock; if a concurrent inserter added an identical table in the meantime the freshly allocated one is freed under the lock, so no duplicate is leaked. qdisc_put_rtab() now decrements the refcount and unlinks under the same lock.

In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: Use sender devcom for MPV master-up After PCIe DPC recovery, mlx5 reloads the affected functions and replays multiport affiliation events. In the reported failure, the first relevant device error was: pcieport 0000:10:01.1: DPC: containment event pcieport 0000:10:01.1: PCIe Bus Error: severity=Uncorrected (Fatal) pcieport 0000:10:01.1: [ 5] SDES (First) mlx5 recovered the PCI functions and resumed 0000:11:00.1. During that resume, RDMA multiport binding replayed MLX5_DRIVER_EVENT_AFFILIATION_DONE and mlx5e sent MPV_DEVCOM_MASTER_UP. The host then panicked with: BUG: kernel NULL pointer dereference, address: 0000000000000010 RIP: mlx5_devcom_comp_set_ready+0x5/0x40 [mlx5_core] RDI: 0000000000000000 Call trace included: mlx5_devcom_comp_set_ready mlx5e_devcom_event_mpv mlx5_devcom_send_event mlx5_ib_bind_slave_port mlx5r_mp_probe mlx5_pci_resume MPV devcom registration publishes mlx5e private data to the component peer list before mlx5e_devcom_init_mpv() stores the returned component device in priv->devcom. A concurrent master-up event can therefore reach a peer whose private data is visible but whose priv->devcom backpointer is still NULL. MPV_DEVCOM_MASTER_UP already carries the sender/master mlx5e private data as event_data. The ready bit is stored on the shared devcom component, not on an individual peer. Use the sender devcom when marking the MPV component ready. This preserves the readiness transition while avoiding a NULL dereference of the peer devcom pointer during affiliation replay after PCI error recovery.

In the Linux kernel, the following vulnerability has been resolved: geneve: require CAP_NET_ADMIN in the device netns for changelink A tunnel changelink() operates on at most two netns, dev_net(dev) and the sticky underlay netns geneve->net. They differ once the device is created in or moved to a netns other than the one the request runs in. The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev), so a caller privileged there but not in geneve->net can rewrite a geneve device whose underlay lives in geneve->net. geneve_changelink() applies the new configuration against geneve->net: geneve_link_config() and the geneve_quiesce()/geneve_unquiesce() pair reopen the underlay sockets in that netns (geneve_sock_add() uses geneve->net), so the same reasoning as the tunnel changelink series applies here. Gate geneve_changelink() with rtnl_dev_link_net_capable(), at the top of the op before any attribute is parsed, matching ipgre_changelink() and the rest of the "require CAP_NET_ADMIN in the device netns for changelink" series. Found by 0sec automated security-research tooling (https://0sec.ai).

In the Linux kernel, the following vulnerability has been resolved: iomap: fix out-of-bounds bitmap_set() with zero-length range ifs_set_range_dirty() and ifs_set_range_uptodate() compute last_blk as (off + len - 1) >> i_blkbits. When off is 0 and len is 0, the unsigned subtraction underflows to SIZE_MAX, producing a huge last_blk and nr_blks value that causes bitmap_set() to write far beyond the ifs->state allocation. Regarding ifs_set_range_uptodate(), it is temporarily safe because len cannot be passed in as 0. However, for ifs_set_range_dirty() this is reachable from __iomap_write_end(): when copy_folio_from_iter_atomic() returns 0 (e.g. user buffer fault) and the folio is already uptodate, the guard at the top of __iomap_write_end() does not trigger because !folio_test_uptodate() is false, and iomap_set_range_dirty() is called with copied == 0. Add a !len guard to both functions before the computation, so that a zero-length range is a no-op.

In the Linux kernel, the following vulnerability has been resolved: fscrypt: Avoid dynamic allocation in fscrypt_get_devices() When a blk_crypto_key starts being used or is evicted, fs/crypto/ calls fscrypt_get_devices() to get the filesystem's list of block devices, then iterates over them and calls blk_crypto_config_supported(), blk_crypto_start_using_key(), or blk_crypto_evict_key() on each one. Currently, the block device pointers are placed in a dynamically allocated array. This dynamic allocation is problematic because: - It can fail, especially at the fscrypt_destroy_inline_crypt_key() call site when it's invoked for inode eviction under direct reclaim. - fscrypt_destroy_inline_crypt_key() doesn't handle the failure. It just zeroizes and frees the blk_crypto_key without calling blk_crypto_evict_key(). That causes a use-after-free. For now, let's fix this in the straightforward and easily-backportable way by switching to an on-stack array. Currently the fscrypt multi-device functionality is used only by f2fs, which has a hardcoded limit of 8 block devices. An on-stack array works fine for that. (Of course, this solution won't scale up to large number of block devices. For that we'd need a different solution, like moving the block device iteration into the filesystem. Or in the case of btrfs, which will only support blk-crypto-fallback, we should make it just call blk-crypto-fallback directly, so the block devices won't be needed.)

In the Linux kernel, the following vulnerability has been resolved: fscrypt: Add missing superblock check in find_or_insert_direct_key() The legacy 'fscrypt_direct_keys' table caches master keys that are used by v1 encryption policies that have FSCRYPT_POLICY_FLAG_DIRECT_KEY. It's just a global table for all filesystems (since the keys can be provided by the legacy process-subscribed keyrings mechanism, which makes it difficult to reuse super_block::s_master_keys). The entries in it ('struct fscrypt_direct_key') do contain a super_block pointer, though, for passing to fscrypt_destroy_inline_crypt_key() when the last inode that references the key is evicted. However, when finding the fscrypt_direct_key for an inode, we weren't actually comparing the super_block pointer. As a result, inodes with different super_blocks could point to the same fscrypt_direct_key. That could extend the lifetime of a fscrypt_direct_key beyond the super_block it points to, causing a use-after-free later. Fix this by creating distinct fscrypt_direct_key structs for distinct super_block structs. Note that this problem doesn't exist in the v2 policy equivalent ("per-mode keys"), since the data structures there are per super_block.

In the Linux kernel, the following vulnerability has been resolved: fs: preserve ACL_DONT_CACHE state in forget_cached_acl() The ACL_DONT_CACHE state is meant to be a constant state for the inode for filesystems that want to opt out of posix acl caching. Commit facd61053cff1 ("fuse: fixes after adapting to new posix acl api") used this facility to opt out of posix acl caching for fuse inodes with fuse server that does not negotiate FUSE_POSIX_ACL (fc->posix_acl). The commit also takes care to gate the forget_all_cached_acls() call in fuse_set_acl() on fc->posix_acl because there is no need for it, but there are other placed in fuse code which call forget_all_cached_acls() unconditional to fc->posix_acl and those cause the loss of the ACL_DONT_CACHE state. This is not only a functional bug. Properly timed, a get_acl() from this fuse filesystem can return a stale cached value, as was observed in tests, because set_acl() does not invalidate the unintentional acl cache. We could fix this in fuse, but it actually makes no sense for the vfs helper forget_cached_acl() to invalidate the ACL_DONT_CACHE state, so let it not do that to fix fuse and future users of ACL_DONT_CACHE.